Madrigal Imaging MP-8 User Manual download pdf (Page 18)

2.4 Mounting

The projector should be mounted after the system design has been

established and reverse scan setup (if required) is complete.

Front Screen ➤

Installations

Floor Mount

Mount the projector on a secured table or cart. Position the projector at the

chosen room location with the projector pointing towards the center of the

projection screen. The angle of projection, combined with the tilt angle of

the screen should direct the reflected image towards the center of the audi-

ence. It is recommended that the difference between the projection angle

and the screen tilt angle (within a common reference) be less than 15°.

Refer to Figure 2-9.

Figure 2-9. Floor Mount Installation

You can adjust projection angle and level by adjusting the height of the

projector legs. See Figure 2-10.

Figure 2-10. Leg Adjustment

Ceiling Mount

Mounting the projector to the ceiling requires the use of a projector ceiling

mount fixture. The fixture is shipped from the factory in kit form (with

assembly instructions) for assembly and installation by the dealer/installer.

For more information, contact your dealer or Madrigal.

INSTALLATION & SETUP

2.12

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 137 138

No comments

Madrigal Imaging MP-8 User Manual Page 18