Madrigal Imaging MP-8 User Manual download pdf (Page 87)

Figure 3-8. Independent IR Keypad Control

Caution: The keypad you are using may become inoperative if its protocol does

not match its setting in the menu.

Remote Jack

This setting determines how the projector responds to devices connected to

the REMOTE jack on the projector’s rear panel. This jack can accept input

from a wired keypad or remote IR sensor. Four settings are available: A or B,

A, B, and Off. If set to A, the projector will only respond if the keypad

using the REMOTE jack is set for protocol A operation. If set to B, the pro-

jector will only respond if the keypad using the REMOTE jack is set for

protocol B operation. If set to “A or B”, the projector will respond to both

protocol settings for keypads using the REMOTE jack. If set to Off, the

REMOTE jack is disabled.

Communication Setup

Press from the Remote Control Options menu

to set the projector identification number and the

RS-232 serial port baud rate.

Projector

This item contains the projector’s identification number. The projector’s

identification number allows IR remote control of a single projector in a

multi-projector installation. To set the projector identification number,

select item 1 then enter a three digit number from 000 to 999. If there is

only one projector in the installation, 000 is the recommended projector

number. For more information about multi-projector control, refer to

section 3.8, Multi-projector Functions.

UTIL

OPERATION

3.45

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 137 138

No comments

Madrigal Imaging MP-8 User Manual Page 87