Madrigal Imaging MP-8 User Manual download pdf (Page 100)

Symptom: The upper portion of the display is waving, tearing, or jittering.

Cause/Remedy: 1) This sometimes occurs when the source is a VCR or video signal.

Change the sync mode by selecting the fast/slow sync option from

the Picture Adjust menu ( ).

Symptom: The upper or lower portions of the display are cut off.

Cause/Remedy: 1) A top or bottom blanking adjustment may be required. Select the appro-

priate blanking adjustment option from the Picture Adjust Menu ( )

then adjust the amount of blanking. Note: A 0% slidebar level indicates

no blanking.

2) A phase adjustment may be required. Select Position from the Picture

Adjust menu ( ). Adjust position so that the entire picture is visible

and centered.

Symptom: One side of the display is cut off.

Cause/Remedy: 1) A left or right blanking adjustment may be required. Select the appro-

priate blanking adjustment option from the Picture Adjust menu ( )

then adjust the amount of blanking. A 0% slidebar level indicates no

blanking.

2) A position adjustment may be required. Select Position from the Picture

Adjust menu ( ). Adjust phase so that the entire picture is visible

and centered.

3) The retrace time of the projector may be longer than the horizontal

blanking time of the signal. Press to change projector retrace

time to Short.

Symptom: Transitions between colors are fuzzy.

Cause/Remedy: 1) Convergence may require adjustment. Perform a convergence on the

selected source.

2) The projector may not be optically aligned for the installation. Has the

throw distance changed significantly since the last optical alignment? If

so, have the projector re-aligned. Refer to section 2.8, Optical Alignment.

Symptom: The display is very faint.

Cause/Remedy: 1) Contrast or brightness settings may be set too low.

2) The projection room may be too bright. Lower the intensity of

projection room lighting. Reduce light reflections as much as possible.

3) The projection room walls and ceilings may be too reflective. Reflective

ceilings, walls, and floors should be kept to a minimum. The best

projection rooms are dark with matte finishing.

UTIL

PIC

MAINTENANCE

4.6

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 137 138

No comments

Madrigal Imaging MP-8 User Manual Page 100