Madrigal Imaging MP-8 User Manual download pdf (Page 71)

Within each zone, a central control point defines the position of each color

within the zone. You will notice that the center position within the box is

most sensitive to the adjustment. This is where the control point is located.

Continue using to move to the next zone/color for adjustment. If you

wish to go back to a previous zone, press . Once all 45 zones have been

converged an Exit dialog box is displayed, as shown below. If you wish to

exit prior to converging all 45 zones, will immediately display the Exit

dialog box.

Note: may be used instead of to change zones/colors, if preferred.

When the Exit dialog box is first displayed,

the cursor bar is positioned on “Save.” Press

, or to save the new settings. To

re-perform the convergence, move the cursor

bar to “Continue Adjust” then press . To discard your changes, move

the cursor bar to “No Save” then press , or .

Interpolated ➤

Convergence

Press from the Convergence Menu to select Interpolated Convergence.

Interpolated Convergence is performed in the same way as that described for

Guided convergence. The primary difference between Guided Convergence

and Interpolated Convergence is noticed during adjustment. In Interpolated

convergence, adjustments are not limited to single zones, but will affect larger

regions of the raster. Response is greatest within the displayed box and

decreases linearity towards zones which have already been converged in the

sequence. Interpolated convergence is recommended when converging a

source for the first time. This method can be much faster than guided conver-

gence. However, it is not recommended if only minor convergence alignment

is required.

RECALL

EXIT

ENTER

RECALL

EXIT

ENTER

CONV

EXIT

ENTER

OPERATION

3.29

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 137 138

No comments

Madrigal Imaging MP-8 User Manual Page 71